![]() ![]() It will be nice to have them in one interface. SYNC IT - the marriage of CUE and Corsair Link into one application. This is the application you use to change light patterns for coolers and fans. While it can control certain Corsair hardware components, most other information is read only, as is typical for any desktop software monitoring program. It can also communicate with specific Corsair PSUs, DRAM, and a few other items. You don't need both.ĬORSAIR LINK - This is the software control center for capable water coolers, fans, Commander Pro, Lighting Node Pro, and general monitoring program. You can use either this or the LNP above for the HD/SP-RGB fans. No RGB strips included, but can be added. This is not a required item and has more features than most people need, but it might be a good choice for someone with poor or few motherboard fan headers and/or a lousy BIOS fan control system. Besides the light control for fans and strips, it can act as a fan controller for up to six fan lines, has 4 temp probe connections and several other related features. It makes a world of difference.ĬOMMANDER PRO - Same as the Lighting Node Pro above, but larger and with more features. ![]() This is not a required product, but if you were going to deck out your case with the SP-RGB or HD fans, you should budget for one. It also comes with 4 LED strips for more flash. LIGHTING NODE PRO - A lighting controller for Corsair SP-RGB and HD fans that allows software integration and much greater control over the LED effects. Its use or necessity varies by product, but the short version is if you need to make it glow or want to change a peripheral, you need software. It can be used for standard DPI adjustments, polling rates, etc. Hope this was of help bud Edited Jby ZottyĬUE 2 - This is the software for managing keyboards, mice, and audio headsets. Sync it Should combine both Cue and Link into one piece of software apparently. I chose the Lighting Node pro as it allowed me to connect 8 lighting strips and also control via link software I chose the Commander Pro because it gave me both RGB and RPM control of 6 of my fans via link software. Here is how mine is set up and the items i used Link is the software used to control both the Lighting node pro and Commander pro (as well as corsairs Coolers/Ram/Psu's) Sync It Doesn't exist for us mortals as of yet and can control up to 6 x Corsair Pro Led Strips or 6 x Hd/Sp rgb series Fans Per Led channel (each set of 6 fans would also need a Corsair Rgb Fan Led Hub) and the Rpm of upto 6 Fans Lighting Node Pro Has two Led Channels and can control up to 6 x Corsair Pro Led Strips or 6 x Hd/Sp rgb series Fans Per Led channel (each set of 6 fans would also need a Corsair Rgb Fan Led Hub)Ĭommander Pro Has 2 Led Channels/ 6 x Fan Rpm/power channels/ 4x temp probe channels/2 x internal usb headers. Cue is for controlling RGB and Macro's on Corsairs Keyboards/Mice/Headsets and Headset stands ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |